NorabNorab - stop-it repair tape to repair pipes
line



RiserRescue® On Site Corrosion Protection

Indumar Riser Rescue Indumar's RiserRescue® represents the latest technology in the remediation of production riser pipe surfaces. Highly adherent, thick polymeric coatings are field installed in regions spanning the splash and light zones near the water surface. These coatings effectively seal the pipe surface from the marine environment, eliminating corrosion and substantially increasing the lifetime of the riser.

RiserRescue® technology benefits:

  1. Refurbishment of existing risers in-situ, avoiding costly replacement
  2. Inhibits corrosion and marine invasion on the coated riser
  3. Eliminates need to shut-in production
  4. Avoids hot work
  5. Will not support combustion
  6. Highly cost effective protection
Riser Rescue

RiserRescue® technology involves the in-situ application of a proprietary, thick, contiguous polymeric coating encasing the riser, extending above and below the water surface.

RiserRescue® employs a rapid-setting proprietary polymer formulation that converts to a solid form within minutes and is fully cured within hours, allowing the product to be applied in a single platform visit.

RiserRescue® coatings are impervious to the penetration of water, thus sealing the riser from the marine environment and inhibiting corrosion of the pipe surface.

RiserRescue® Riser Rescue proprietary coatings provide a protective barrier in the marine environment, inhibits biological invasion of the riser and significantly eases cleaning.

RiserRescue® thick, durable proprietary coatings seal the riser from marine invasion, thereby providing physical and corrosion protection.

RiserRescue® proprietary coatings exhibit favourable elastomeric properties, yielding thermal stability of the steel-coating interface over a wide range of application temperatures.

RiserRescue® applications are handled by licensed installers possessing all the necessary equipment and training needed to provide efficient and safe product applications.

Physical form:
Thickness:
Length:
Riser diameter:
Colour:
Hardness:
Stability:
Curing:
Solid, continguous coating, closed cell & non-swelling
Approximately 1 inch
Typically 6ft above and below the water line, increasing as required by the clarity of water
4-12 inches (other sizes available upon request)
Safety orange (other colours available upon request)
75 Shore A
Resistant to UV degradation, will not support combustion
10 minute working time, 2 hour set time, full hardness in 24 hours

 

 

 

 


Norab Services Limited - Your Source for InduMar Products
UK Toll Free Tel: (0)800 092 0725 | e-mail: info@norab.eu
line